1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Packard Bell AM/FM radio
Arran
Phorum Expert
*****
Posts: 4,705
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#1

06-21-2013, 12:17 AM
Hi;
About two weeks ago someone gave me a Packard Bell AM/FM radio along with a bunch of other assorted junk. I think it is a model 7R3 from around 1959-60, seven tubes, series string, selenium rectifier, two knobs, ruler dial, and a basic wooden box cabinet with a faux wood grain. If someone has a circuit diagram for one of these please let me know.
Regards
Arran
Find
Arran
Phorum Expert
*****
Posts: 4,705
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#2

07-02-2013, 10:59 PM
I guess it's about time to give this thread a bump. I did manage to get it playing somewhat on both bands, there were two bad tubes, a 50EH5 that was shorted and a very weak 12AT7. The AM broadcast band works reasonably well, the FM works but is very weak. I put it into dry dock for now until I can find the proper service information.
Regards
Arran
Find
chris25260880
Member
***
Posts: 73
Threads: 11
Joined: Feb 2012
#3

07-02-2013, 11:03 PM
I always loved Packard Bell stuff but as I remember they seemed to be sold only on the West Coast
Find
Arran
Phorum Expert
*****
Posts: 4,705
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#4

07-03-2013, 09:08 PM
Some of it is built kind of on the cheap side, but they were an RCA licensee so they used pretty reliable and proven circuits, at least on their older stuff from the 1930s and 40s.
Regards
Arran
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 5687 online users. [Complete List]
» 1 Member(s) | 5686 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)