1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
37-116 grill cloth
LASJayhawk
Senior Member
****
Posts: 289
Threads: 40
Joined: Oct 2011
City: Las Vegas, NV
#1

09-22-2013, 05:27 PM
Ok maybe a dumb question, but in the cutouts for the 2 outer resonators, was the pattern a V centered in the cutouts or \ in the left and / in the right?

Wondering cuz the reproduction cloth is 18" wide and the sounding board is 23 1/2" wide. Seems like if was one piece 24" wide a littler wider reproducton cloth would be nice.
John
Las Vegas, NV USA
Find
bfrohwein
Member
***
Posts: 152
Threads: 11
Joined: Feb 2013
City: Dallas, TX
#2

09-22-2013, 06:06 PM
I wondered the same thing.. seems like everyone who is carrying this new design only sells 18x25.. I wonder if they make it any wider. seems like a sad oversight on their part. there are plenty of the consoles around needing TLC..
Find
Phlogiston
Radio-Fixer-Upper
*****
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
#3

09-22-2013, 07:33 PM
Even the old stuff would not fit the 37-116 unmodified. There are Vs in both of the smaller grills.
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Website Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4794 online users. [Complete List]
» 1 Member(s) | 4793 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration