Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco ventilator
#16

looking good


Attached Files Image(s)
   
#17

red lacquer finish .


Attached Files Image(s)
   
#18

new bushings and felt oilers and rivets .


Attached Files Image(s)
   
#19

the rubber mounts were suppose to be the same size on both ends but one cap end was a good bit smaller ..an old leather belt solved the problem .


Attached Files Image(s)
   
#20

new head wires and drummed sanded the stator with 220 .


Attached Files Image(s)
   
#21

ready to go back into the box .


Attached Files Image(s)
   
#22

It's up to you of course but I think that some medium walnut, dye based, toner would even out the lighter walnut veneered portions of the cabinet. Nice work on the motor repairs by the way, and fixing the broken grill bars in the front.
Regards
Arran
#23

http://youtu.be/UnOULsnYlmQ
#24

......


Attached Files Image(s)
   




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4908 online users. [Complete List]
» 1 Member(s) | 4907 Guest(s)
Avatar

>