Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 512 red mandarim: flowers and bird
#1

1) Does anyone have good photos or knows where to get them showing
the flowers painted on the front of the set and the bird on the lid?

2) Were the flowers and the bird made according to a only one pattern or were there multiples patterns? Icon_confused: Icon_exclaim
#2

I can tell you that the patterns on the 1928 Philco painted table models were all hand-painted; thus, there will be variations in the patterns from one set to another. Nevertheless, each model followed a distinctive pattern; i.e. the painted flowers and the bird on the 512 Mandarin Red will all be very similar, but not exactly identical.

I have a Mandarin Red 512, but it is badly scratched up, so I doubt if photos of it will help you.

--
Ron Ramirez
Ferdinand IN
#3

Hi,

I found this on-line sometime ago and perhaps it will be of some help:-

http://www.goantiques.com/scripts/images,id,900544.html

Paul
#4

there's a pic of mine at http://www.radioatticarchives.com that may help,phil




Users browsing this thread:
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently no members online.

>