Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 41-315X
#31

looks great
#32

I'm posting hear as we had discussed the pilot lamp earlier. Today I took home a 39-116 with its remote...THIS one still had a lense in it...a clear, faceted lense. Everything with this set appear original....Not sure if I want to pop this out and use one of my red lenses that worked very well in my 42-400...Any thoughts?
#33

is the clear lens 3/8" or was the hole drilled out to accommodate a 1/2" common faceted lens? personally I'd have gone with a faceted glass lens if I could've found one that would fit in the existing hole. as far as I know, and ron demonstrated, these usually came with cheapo plastic lens.

if it looks good with the faceted clear, why not try using a colored bulb?

http://www.pinballlife.com/index.php?p=c...ent=2&pg=1
#34

funny.. I just went back and realized there was all sorts of activity on this thread when I running back and forth from Texas to California (family issues). that radio looks amazing! looking at the escutcheon, you have a much steadier hand than I do. the lines look amazing!




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>