1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
philco 39-36 pushbuttons
mhamby
Junior Member
**
Posts: 6
Threads: 4
Joined: Apr 2014
City: Independence, MO
#1

04-23-2014, 04:27 PM
I am finishing a 39-36 Philco console and have a question about replacement pushbuttons. I think I need the long pushbuttons that are available from Renovated Radios. What was left of the pushbuttons that came with the radio had a brass clip on each pushbutton. The old pushbuttons are in such bad condition that they are not much help in determining which replacement pushbutton would be correct. I would appreciate any advice on which is the correct pushbutton. Also what was the purpose of the brass clips on the old pushbuttons?
Thanks in advance for any help that you can give me.

Marion
Find
tab10672
Senior Member
****
Posts: 411
Threads: 42
Joined: Sep 2008
City: Ironton Ohio
#2

04-24-2014, 02:35 PM
I think someone posted here that the brass springs/clips were there to block light from the dial lamps
Find
« Next Oldest | Next Newest »




Users browsing this thread:
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4820 online users. [Complete List]
» 2 Member(s) | 4818 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration