Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Photo's Needed
#1

Hello All,

(Ron, I hope this is in the correct Discussion.) I'm putting together a little monograph on the Plant A radios. I am in need of some clear digital photos of the Plant A, Plant C, and Factory F patent plates. Factory F plates can be found on Empire, Climax and Federal radios. Also I'm looking for a photo of a schematic from the cabinet and some front and rear shots. And lastly, I'm trying to find a photo of a Gaylord Syncratone radio. Any help will be appreciated and your name in the credits! Thanks, Joe

Joe

Matthew 16:26 "For what does it profit a man if he gain the whole world, yet lose his own soul?"
#2

Don't know if these will serve you.

   

   

   

That Clinton tag is rarely seen. There is ongoing debate about just what connection there was between Clinton and Plant A. Worth noting that these Plant A/Clinton tags are the same size, color and font as the earlier Silver-Marshall tags.
#3

Exray, Many thanks for the jpeg's. I've never seen the orange tag with the Clinton logo before. This is going to sound odd, I should know your name beside 'Exray', but I don't. Would you PM your name to me so I can give attribution in the article? Again, many thanks. I can still use some front and rear jpeg's of Plant A, Plant C and Factory F radios if anyone out there can help. Joe

Joe

Matthew 16:26 "For what does it profit a man if he gain the whole world, yet lose his own soul?"




Users browsing this thread:
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6982 online users. [Complete List]
» 2 Member(s) | 6980 Guest(s)
AvatarAvatar

>