41-623 BOL

Pages (2): « Previous 1 2

Thread Rating:

41-623 BOL

Crist Rigotti
Senior Member

Posts: 384
Threads: 22
Joined: Mar 2015
City: Waxahachie, TX

#16

08-30-2015, 11:07 PM

Here is a link to another source for the photo cell.

http://myarduinoonline.com/udt-silicon-p...l?cPath=78

Crist

Find

sam
Phorum Expert

Posts: 2,572
Threads: 337
Joined: Jun 2013
City: lawrenceville nj

#17

08-30-2015, 11:22 PM

hey greg
I don`t know if these will work but I`m going to try
http://www.ebay.com/itm/Selenium-photo-s...fresh=true

sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2

Find

« Next Oldest | Next Newest »

Pages (2): « Previous 1 2

Users browsing this thread: 5 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5214 online users. [Complete List]
» 1 Member(s) | 5213 Guest(s)