Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 95
#1

Hi Guy's,
Posted a thread before about a model 95 I brought home last week.
Aaron was correct about the cabinet being refinished. After looking it over closely and comparing to an original 95, I can see it now.
Probably won't refinish it though as I am going to sell it anyway.
The radio plays perfectly, but of course I had to remove the chassis and the bottom cover plate just to see if it has ever been re-capped.
Kind of a strange layout as compared to what I usually work on.
Appears to be unmolested.
Caps are held in with brackets or clips and some are wired to the side of the cap.
Resistors all appear to be original.
I am amazed that this still plays like a new radio with as old as it is.
Looking at Nostalgia radio schematics, I do not see a parts list.
Don't see that the caps are marked either.
One page of the schematics does show part ID numbers on the caps.
Anyone have a parts list for this radio?
murf
#2

http://www.philcoradio.com/tech/images/95.jpg
Note a few of the caps have resistors molded in with cap. Easiest way to repair is to cut the gnd lead off and solder new cap under the old one.
Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM
PT 6 chassis screws size???
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM

[-]
Who's Online
There are currently no members online.

>