1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco 16B Band 5 problem
Kenradio
Member
***
Posts: 98
Threads: 20
Joined: Nov 2011
City: Tiffin, Ohio
#1

08-22-2015, 07:14 AM
Hello everyone, I have a Philco 16B (Code 121) tombstone radio I have restored and it is working great except for the 5th band where from 11 MHz to 13.5 MHz there is no reception--oscillator is not working. From 13.5 to 23 MHz it is working like it should and WWV is right on 15 MHz. I checked the 76 oscillator tube and it is good and I reduced the value of the 50K resistor to 33Kohms on the plate circuit of the 76 tube but no change. I also subbed out the .0007 MF capacitor--still no change and I cleaned the bandswitch. I checked the cathode resistor and it checks out ok (510 ohms) All other bands work properly. I have read this was an issue with this chassis. Has anyone successfully fixed this problem with the oscillator dropout issue? Thanks, Ken
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5036 online users. [Complete List]
» 1 Member(s) | 5035 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration