Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Phorum How-To #17: Mark Forums as Read
#1

Quite simple, really...

If you visit one of the forums within the Phorum, read the threads you want to read, and then want to mark the rest as "read" all at once - proceed as follows:

Let's assume you are in Philco Home Radios.

Look close to the top of the page, to the right of where it reads Philco Home Radios and under the big Post Thread button.

Look for the Mark this forum read link (see below).

[Image: https://philcoradio.com/images/phorum/Ph...17_001.jpg]

Click or tap it.

You will then see this message:

[Image: https://philcoradio.com/images/phorum/Ph...17_002.jpg]

The message will go away in a few seconds and you will be back on the main page of the forum you were in.



Now let's say you visit the Phorum, but don't want to read any of the threads in any of the forums. You want to mark all of them as "read".

Just scroll all the way down to the bottom of the Phorum home page and look for the Mark All Forums Read link as shown below (the view on phones is similar):

[Image: https://philcoradio.com/images/phorum/Ph...17_003.jpg]

Click or tap it, and then you will see this message:

[Image: https://philcoradio.com/images/phorum/Ph...17_004.jpg]

In just a few seconds, the Phorum home page will reappear.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently no members online.

>