Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

audio woes on the 38-5
#16

I have a Emerson,,,some of the same things,,,,,Out of the Blue,,,I decide to Ground the chassis to the cold water pipe,,,,and wow,,,it start picking up everything,,,, CHEERS
#17

Well I'm happy to report the 38-5 is alive and well and singing as she should. Turns out it was the #42 cap. It was in the right place, but it didn't have a good ground connection. Once that was resoldered, it behaved again. I cannot thank Terry (Radioroslyn) enough for his help on this and so many other projects. He spent the good part of an evening on speaker phone with my dad and I trying to sort this out and the #42 cap was one of the first components he suggested checking. Terry's vast knowledge is equaled only to his vast patience. He is a true gentleman and we are so lucky to have him with us on the Phorum. Hat's off to you, my friend. Thanks again. Icon_clap

   

   

Greg V.
West Bend, WI
Member WARCI.org




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3352 online users. [Complete List]
» 1 Member(s) | 3351 Guest(s)
Avatar

>