1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
47 1230 no fm
willydcamaro
Member
***
Posts: 69
Threads: 4
Joined: Apr 2016
City: washington nj
#31

04-07-2018, 07:13 PM
Hi everyone. I need a picture of the 9 lug terminal strip running parallel to the bandswitch. I think there are some wires are wrong, including c419 connections. I removed c419 connections and now have hi voltage back after r100. Any help would be greatly appreciated. Thank you,Bill
Find
willydcamaro
Member
***
Posts: 69
Threads: 4
Joined: Apr 2016
City: washington nj
#32

04-09-2018, 07:52 PM
Hello to everyone... please help me, Bill
Find
willydcamaro
Member
***
Posts: 69
Threads: 4
Joined: Apr 2016
City: washington nj
#33

04-30-2018, 07:44 PM
Well I took a break from my 47 1230... maybe forever. I've had a 42 355 I recapped a long time ago and never really played it much. I just made an antenna with a loop wire and tuned in the 42 355. Wow! This thing plays fantastic. Stations up and down the dial and pretty good s/w. Impressive set.
Find
Marsupial
Senior Member
****
Posts: 336
Threads: 13
Joined: Apr 2011
City: Montreal, Qc
#34

08-01-2018, 07:17 AM
Hey Bill, how is your 47-1230 going? Those are awesawe radios.

I have all the official philco tech papers for it, scanned and all. PM me if you are iintereste.

On mine, the FM is significantly lower volvol than anything else. Have you cranked up the volume?

My FM waswas playing until I interchanged its tube a couplc times and I assumed the connector had somsometh to do with that. 

There's also some 3-way cap that is leading to troubles. 

Post pictures of yours.
-Mars
Find
« Next Oldest | Next Newest »




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6926 online users. [Complete List]
» 1 Member(s) | 6925 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration