Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 89 (code 121) parts list
#1

I have looked for this and hope I haven't missed it somewhere. Can anyone point me to a parts list for the Philco 89 Code 121 cathedral? There is a bottom view of the chassis showing parts in Riders 3-34 with the schematic on 3-33, but I cannot find a page telling me what the actual parts are. I am mainly wanting to know the capacitors before pulling the blocks out. I know I can look at the block numbers and figure it out, but sometimes you have to pull it to see the numbers. I see a parts list for the 89 code 123, but numbers are different.
Thanks,
Scott
#2

Welcome to the Phorum! Icon_wave

Here's a must view link: http://www.philcoradio.com/phorum/showth...?tid=15002 that has the evolution of the model 89 showing the changes in the circuits over the years. Ron, our founder, put this together and should be very helpful. It does not have a list of parts but the schematics are very readable.

Also try: http://www.audiophool.com/Philco.html where you can view Service Bulletins #146 and #146B. They have lists for the 121 and 123 respectively. you need to download the djvu reader to view the images. If you have trouble let me know.
#3

Thanks Bob,
I can make it with those very easily.
Thanks Again,
Scott




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM

[-]
Who's Online
There are currently no members online.

>