Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What do I have here?
#1

Hello to all,
While out digging thru a few antique stores today, I ran across this little gem. It is a small bakelite with leatherette panels and a brass or gold colored grill over the speaker.  It is AC powered, no battery compartment.  AM broadcast band only. It opens up, as shown.  The chassis appears to be encased in a perforated metallic case within the bakelite shell. The loop antenna is attached to the back side.  The controls are two thumb wheels on the top, front area.  I have never seen anything like it. It does have the Philco name on the front.  The paper tag on the inside is almost completely destroyed from damage by cord storage.
Any ideas what I might have here? Model no. etc.?

Thanks for looking.    

   

Chris H
N9WHH
#2

https://philcoradio.com/gallery2/1949a/#Model_49-603
Standard ac/dc set w/an odd cabinet.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Thank you Terry. I looked around but couldn’t find anything that looked like it. It appears to be in pretty good shape and should clean up well. I figured it was an AC/DC chassis.

Thanks, again.

Chris H
N9WHH




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4498 online users. [Complete List]
» 2 Member(s) | 4496 Guest(s)
AvatarAvatar

>