Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Video of my electrically restored 1952 Motorola 52X
#1

I left the cosmetic's alone because that is not my department.  Icon_lol This one took considerable work to make it live again replaced all the caps and resistors along with a 12BD6 tube, speaker, power switch and rubber tuning capacitor grommets no silver mica disease here. 

Sorry for the lack of tuning because there is not a great selection in the day time. Strange it uses a 12BD6 in place of the 12BA6.
https://www.youtube.com/watch?v=6s9s-lSIwQs
#2

sound is pretty good!!!
#3

Nice!
#4

Like the funky tuning indicator on the top. WSM Icon_thumbup

I have tried to pick up WSM up in Boston only to shut out all the time, used differing antenna, different sets, etc........

Enjoy.

Paul

Tubetalk1
#5

"Strange it uses a 12BD6 in place of the 12BA6."



You're like me, . . . you got used to seeing the same 5 in the All-American-5 plastics tabletops, ( I could recite them by memory by the time I was 13), . . . then got bent out of shape when you discovered they weren't the original 5 !   Icon_crazy

Nice work bud.
#6

I also like the odd tuning indicator, sounds good Jake...

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"




Users browsing this thread:
[-]
Recent Posts
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM

[-]
Who's Online
There are currently no members online.

>