Posts: 3
Threads: 1
Joined: Sep 2019
City: Trinidad
State, Province, Country: Colorado
Hello,
Just found a cool old 50-1721 in a basement. I'd love to use it. It gets a hum at high volume. It turns but no sound unless its set at high rpm so you hear chipmunks but no sound at the correct speed. Any ideas?
z
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
Hi Zeb and welcome to the Phorum,
Several thing come to mind. Would service the chassis by testing tubes and resistors replace foil/paper caps along w/ eletrolyics. This will give you a good starting point to do any further troubleshooting.
The turntable give it a mechanical cleaning and lub. Not uncommon to find deteriorating rubber parts (driving the platen) that will need replacement. Another common issue is a weak cartridge (low output) and low tracking pressure.
After 69yrs these sets aren't a plug and play unit any more.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 3
Threads: 1
Joined: Sep 2019
City: Trinidad
State, Province, Country: Colorado
Thank you very much... so far that is all a mystery to me so I'll start looking into how to do all that. I'd love to get it working again.
Posts: 816
Threads: 25
Joined: Mar 2014
City: Louisville, KY
Whatchu got against chipmunks?!
Posts: 3
Threads: 1
Joined: Sep 2019
City: Trinidad
State, Province, Country: Colorado
Nothing really I just don't chipmunks in my vintage pre-chipmunk turntable
Posts: 816
Threads: 25
Joined: Mar 2014
City: Louisville, KY
HA! ok bud.
Terry is good , smart help. There's lots of good help here.
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry