Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

How popular was the Philco 87?
#1

As I test and revive the Philco 87 lowboy in my bedroom, a question has come to mind: Just how popular was this model? I know in my area if a 1929/30 era Philco console appears for sale that there is a 90% chance that it's an 87. In fact, I am amazed at how often this model still pops up for sale, though not as often as in the past with the occasional 95 in the mix. I think I have seen only one model 65 pop up for sale all these years, but it was about three hours away from my place! Icon_eek  I have only run across parts chassis in my area for the model 65 and 76 in my neck of the woods. So, either the 87 was super popular or the salesmen in the Cleveland, Akron, and Canton, Ohio regions were really good! Icon_smile Heck, I have three myself! Two lowboys and one highboy!

P.S. My good lowboy still works and acts like I had just used it the yesterday, in spite of sitting for over a year. Not bad for a semi-restored radio! Runs a lot cooler on that resistor box I had made. That former Zenith employee did a good job on that! Icon_biggrin

No matter where you go, there you are.




Users browsing this thread:
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM

[-]
Who's Online
There are currently no members online.

>