Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

DeForest Crosley console
#1

I bought this radio from a fellow in Edmonton, and I have it recapped, and playing good.
 I had to rebuild the system that controls the dial. It is a system that uses  a wire wound around the tuning dial knob and the top portion with the actual dial.
   The indicator is three lights that rotate around as you change stations. Each band has its own light.
   I will get to the cabinet in the spring. It is not a high tube count, but I really like the cabinet and the dial.
   I have a pretty good idea of what it will look like after I am done.
 
These Rogers and DeForest  radios all have very nice dials.   It Is a model  7D932
 Dan in Calgary


Attached Files Image(s)
                           

   Living in Calgary Alberta
#2

Dan;
  Is that a Deforest Crosley "Prescott"? Someone donated the remains of one in a local military museum, both I, and the man in charge, really wish that they had have left the original innards in it rather then getting cute trying to turn it into a glorified speaker. So I have been keeping my eyes open for a junker, with a trashed cabinet, or a spare chassis to put it right. Of course I have to keep my eyes open for a junk chassis/set to donate an IF can for my D.C "Brahms". 
Regards
Arran
#3

The radio that I have is  called   the  Laurentian. The Prescot has a different cabinet ,with different grill bars.
 I suppose that they both have the same chassis. Here is a photo of the Prescot.
 Dan in Calgary


Attached Files Image(s)
   

   Living in Calgary Alberta
#4

Dan;
  Never mind, I found the difference, the "Laurentian" has nine tubes, whereas the "Prescott" has eight. In this case it looks like the "Laurentian" has a tuned RF amplifier stage as it has two 6K7Ms, that a neon bulb. https://www.radiomuseum.org/r/deforest_l...7d932.html
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>