Model 71H Bakelite block 4989-L

Thread Rating:

govee
Junior Member

Posts: 15
Threads: 5
Joined: Jan 2020
City: Lexington Park State, Province, Country: MD

01-11-2021, 04:14 PM

I see that this block has a 200 ohm resistor in it from pins 3 to 8. What is the wattage of this resistor?

Andy

Find

morzh
Odobenus rosmarus

Posts: 15,818
Threads: 554
Joined: Oct 2011
City: Jackson, NJ

01-11-2021, 05:48 PM

If this is the one in the cathode paralleled by a cap, it can be 1/4W and that is plenty.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.

(This post was last modified: 01-11-2021, 05:49 PM by morzh.)

Find

govee
Junior Member

Posts: 15
Threads: 5
Joined: Jan 2020
City: Lexington Park State, Province, Country: MD

01-11-2021, 07:22 PM

It is as you describe. Thank you

Find

« Next Oldest | Next Newest »

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6860 online users. [Complete List]
» 1 Member(s) | 6859 Guest(s)