Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Asking for help with Philco Ford Mini Phono/Radio Model S-1379GR
#1

Hi everyone,
I recently lucked into finding a pretty cool Philco Ford Miniature Radio/Phonograph at a Salvation Army. I took it home, popped in some C batteries and the radio seems to work excellently, playing out of the speaker. The phono motor works and seems to run at proper speeds, but no sound is coming out of the speaker. Seems odd because the speaker clearly works with the radio. I’m wondering if the needle cartridge might need replacing or if there may be a lose wire from the phono arm?

In any case, I know this forum is mainly for older  Philco radios and tvs but I was just wondering if anyone had any experience with this device.  Maybe an old manual or just happen to know if there’s a replacement needle cartridge that will work.

Thanks for any help you can give!
#2

Welcome to the Phorum! Start with the cheap and easy stuff. Clean the selector switch contacts and check for possible loose wires. Would not be an unusual instance for the cartridge to be needing replacement, but start with basic 'once-over' simple options first. You just might get lucky. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM

[-]
Who's Online
There are currently 1632 online users. [Complete List]
» 4 Member(s) | 1628 Guest(s)
AvatarAvatarAvatarAvatar

>