Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 50 Capacitor values
#1

I am currently restoring a Philco Model 50. The capacitor block, C15, contains 5 capacitors. The color coding of the wires from this block are no longer identifiable. The schematic shows four of the five capacitors but does not include capacitance values.

Does anyone know the values for each of the circled capacitors in the attached schematic?

Thank you

Don


Attached Files
.pdf CCF_000012.pdf Size: 603.24 KB  Downloads: 129
#2

Have you looked here?

https://philcoradio.com/library/images/schem/50.jpg

--
Ron Ramirez
Ferdinand IN
#3

hello don,
Leave it to Ron that exactly the page I was looking for !
Sincerely Richard
#4

Thanks, Ron. Found what I needed at the link you provided.

Don




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6789 online users. [Complete List]
» 1 Member(s) | 6788 Guest(s)
Avatar

>