Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA Model M101 M104 M108 auto radio 1934
#1

First let me say that the passing of Ron Ramirez was noted with sadness on the website of the New Zealand Vintage Radio Society. R.I.P. Ron 
I have come across an RCA Model 101 104 108 auto radio.I have been able to identify it thanks to info gleaned from the Phorum . Thanks everyone.It has been modified and a speaker box grafted onto the front. Does anyone know where I can see a photo of it as original? Also  was this set an aftermarket model or was it a set installed in particular makes of car?  Any help appreciated. Thanks everyone.
#2

Some links that I hope will help. Good luck David  https://www.radiomuseum.org/r/rca_m101.html       https://www.retroradioshop.com/pages/ide...rca-victor        http://www.rfcafe.com/references/radio-c...e-1935.htm




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Model 96 cabinet veneer
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM
Philco 38-2 Low Volume
I managed to get some more time on this. Hi Mr. FixIT, The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM
Philco 38-2 Low Volume
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM
RCA WV-98c
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM
Philco 38-2 Low Volume
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM
RCA WV-98c
Those will probably depend on teh switch combination. Could you list some that you see, their values and what they sh...morzh — 10:26 AM
Model 96 cabinet veneer
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM
RCA WV-98c
At this point, there is no input, just internal voltages Which are incorrect and not sure what they should be.daveone23 — 09:15 AM
Philco 38-2 Low Volume
Hi DConat, Generally, the lower the plate voltage the less negative the grid voltage has to be. Since the plates an...MrFixr55 — 09:27 PM
RCA WV-98c
If I had it in front of me, I would triy to trace the signal on one of the non-working functions. Try to trace and high...morzh — 08:21 PM

[-]
Who's Online
There are currently 1222 online users. [Complete List]
» 1 Member(s) | 1221 Guest(s)
Avatar

>