Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x


ID request Pacific radio “Rex”
#16

Karl;
That is a type of wire wound resistor called a "Flex Ohm" that became popular from the mid 30s up until the war, they have fabric covered sleaves on them which often deteriorate either from age or the resistor becoming overloaded, thus looking like a miniature slinky. I think they were used as more compact substitutes for a carbon comp resistor of the same Wattage as they were typically under 5 Watts, and as the name implies you could also bend them somewhat. I looked up that model 15 Pacific schematic on N.A and that resistor is nowhere to be seen, not only that but it makes no sense. Pin 6 and 1 of the 6C6 are for the heater, pin 5 is the cathode, and pin 6 should be connected to either pin 1 or pin 6 of the 6D6 , not through a resistor to ground.
That being said I can see some questionable work was performed on this radio is the past, such as the leads of some components being used as junction points for others, as well as what may be used parts being installed rather sloppy.
Regards
Arran
#17

Repeat post
#18

I'd agree. That work isn't mine!! I've established it works. Now I'm going back through it. The values on the PS cap are wrong and need to be replaced.
I've temporarily replaced that Flex-ohm "slinky" with a 40 ohm resistor so I don't get a short . I need to figure out what's happening with that part.




Users browsing this thread:
[-]
Recent Posts
Philco P45-6365 Universal Transformer Instruction Manual
Can anyone guide me to where this may be found?GRG — 03:00 PM
54C Complete Teardown/Rebuild
I don't think that I have encountered a 12Z3 before, curious how it uses one of those but includes a #43, which is a 25 ...Arran — 02:17 PM
HiFi (Chifi) tube amp build - but my own design.
It's the other forum. I'm also in DIY, but mostly read there. Honestly, I kinda jumped into this without much thought to...TV MAN — 10:43 AM
Philco 71 Code 125
Hello,  I am in need of a schematic for this radio. Mine has the three separate circular tube shields and a shadow me...dconant — 08:06 AM
Stromberg Carlson 1500 Squeal
And life just keeps getting more complicated.dconant — 07:57 AM
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM

[-]
Who's Online
There are currently no members online.

>