Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PT-43 reception question
#1

Hello Folks,
Well, I just recapped this little one and it plays very well with outstanding AM reception! So here's the question - I know that this SW section (1.5>2.5) is pretty much history, but when you throw the switch on the back to the police section it sounds like a switch was made but it continues to recieve AM. Any idea why? The switch appears to be wired correctly, unless I'm missing something.
Jim
#2

Well, from 1500 KHZ to 1710 is part of today's broadcast band. There will be lots of AM stations in this part of your "police" band. The rest should be pretty quiet. Or do you mean that there is no change at all when the switch is thrown and the stations come in just as they did before?

Steve Chambers
#3

Hi Steve,
Well, after I read your reply I had to go check again. Most all the reception is in the 1450 up area, but very, very faintly you can hear the local Hispanic station which broadcasts @ 960 AM. Not really a crisis, but made me curious.
Jim




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

[-]
Who's Online
There are currently 6149 online users. [Complete List]
» 1 Member(s) | 6148 Guest(s)
Avatar

>