Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Volume won't go completely down
#1

Hi,

I bought a Philco 84B that had no volume control, the sound would not go up or down. I found that the antenna transformer primary was open. I had the transformer rewound, now the volume goes up and down but not completely down. There is always sound coming from the radio even when the volume control is at the minimum. Any thoughts?
#2

Sound out of a radiio iis always a good sign. Perhaps he On/off switch is shorted. I wish they were all that easy.
#3

In model 84, the volume control is between the antenna terminal and ground. If the radio is not grounded, the volume won't turn all the way down. So...you need to connect the GND terminal to a good ground.

Please note that even if grounded, you still may not be able to turn the volume down completely on strong local stations.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Testing a speaker and output transformer Trutone A2-G
The transformer may be the last cause of voltage drop. This level of voltage drop is not too big. Conduct additional te...Vlad95 — 07:16 PM
Testing a speaker and output transformer Trutone A2-G
Well I have found 315v on the rectifier when cold. Drops off to 280 after 15 minute warmup. Checked pin 3 on both 6F6 t...murf — 04:14 PM
Testing a speaker and output transformer Trutone A2-G
Thanks for the replies, I will check these ideas out and report back. murfmurf — 03:18 PM
Testing a speaker and output transformer Trutone A2-G
Sorry, my mistake. murfmurf — 03:07 PM
Testing a speaker and output transformer Trutone A2-G
MrFixr Honestly, I haven't done that yet and do not want to screw up the threads; maybe you could do it, or we could...morzh — 12:48 PM
Two small radios from France. Restoration and review.
Greetings; I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM
Philco model 38 code 121 not receiving signal.
Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM
Philco model 38 code 121 not receiving signal.
Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM
Philco Battery-WWII vintage
Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM
Testing a speaker and output transformer Trutone A2-G
Hi Morzh, From my end, no. I did not know that there are 2 threads on this topic. Maybe it should be combined.MrFixr55 — 07:13 AM

[-]
Who's Online
There are currently 233 online users. [Complete List]
» 3 Member(s) | 230 Guest(s)
AvatarAvatarAvatar

>