Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 77 Parts Layout sheet
#1

Hello all,

I am new to this forum and will be using it as a great info source for my Philco Model 77
Restoration project.

I am just starting and have restored the cabinet, now on to the chassis.

The radio I have looks fairly intact, it is missing the 2 -45 tubes, and looks like the two of 3-24s have been replaced with 58's.

I will be looking to replace all the capacitors and checking/adding tubes prior to power up!

Q. I have the schematics, but need the component layout to id the parts.

Does anyone have or know where I can get a copy of the component layout?I have checked most internet sources with no luck.

Thanks
Tony
#2

Hi

I suggest you purchase the complete set of service information from Chuck at the Philco Repair Bench website. This will include everything you need, and the price is quite reasonable.

http://www.philcorepairbench.com/schematics.htm

--
Ron Ramirez
Ferdinand IN
#3

Thanks for the link. I will check it out.
#4

Chuck's service info is outstanding. Very thorough. Highly recommend! Icon_smile

Mike
#5

Just out of curiosity which cabinet does it have?
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#6

Its a lowboy cabinet.
Picture in its original condition attached.

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.
#7

Nice!!!
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread:
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>