Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need turntable for 48-1270 phonograph
#1

I just gutted my Philco 48-1270 and sent the radio chassis out for a rebuild. Now that it's under way, I need one missing part; the turntable "platter" for the phonograph. Grandfather loved trains and used the original one to build a roundhouse for his layout decades ago, so it's gone forever.

Anyone have a platter they can sell?
#2

This is a "Wanted Ad" and belongs in the "Wanted Ads" section.

However, you have already posted an ad there, so I am locking this thread.

Multiple postings on the same subject are not allowed under Phorum rules.

Quote:II. Multiple threads on the same subject not allowed.

When you start a thread, please keep the discussion within the same thread.
http://philcoradio.com/phorum/showthread.php?tid=4586

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 5294 online users. [Complete List]
» 5 Member(s) | 5289 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>