Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco decal needed
#1

Just finished one of my 16B's and need to buy the Philco decal as the cabinet was completely stripped when I bought it. Anyone know who sells the correct one for this cabinet?


[Image: http://i989.photobucket.com/albums/af14/...rchtop.jpg]

Click the thumbnail to view a larger photo. (edited by site admin)
#2

What you want looks like this:

[Image: http://i326.photobucket.com/albums/k420/...36phil.jpg]

If you order the PH-HiFi decal set from Radio Daze, and use one of the decals with the words "HIGH FIDELITY" in small block letters underneath the PHILCO trademark, cut off the "HIGH FIDELITY" and you will have an authentic decal.

By the way, your 16B sure looks purty. Good job! Icon_thumbup

--
Ron Ramirez
Ferdinand IN
#3

Thank you very much Ron. I would have never figured out which decal to use!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>