Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 42-1002 Code 122
#1

I have a Philco Model 42-1002 Code 122 that my parents had in the 1940s.

I side the back there is a label which states:
Built for Television Sound
The Wireless Way when used with Philco Television Picture Receiver
Need No Wires, plug in or Connection of any kind.

The wiring and tubes look in pretty good condition except that the power cord is in bad shape.

I am trying to determine if the radio has any value other than it brings back a lot of memories.

Does anyone have any info about this model!

Old Kid 2
#2

It's not a terribly collectable radio, a fairly basic radio phonograph. But if it has value to you that's what's important. That being said it's a relatively inexpensive radio to restore too, and the phonograph is a simple single speed unit without a changer mechanism.
Regards
Arran
#3

Thanks for your input Arran!!!!!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM
two videos to watch VHS and history of TV
Hello Every, Here are a couple videos right up my alley VHS and the history of Television . history of VCR VHS Hi...radiorich — 02:13 PM
Made mistake & did not label connection
You haven't given us the model number of the set so I looked up the 6A8 pin assignment. Pin 8 is the cathode and pin 7 i...RodB — 01:19 PM
Made mistake & did not label connection
Happy Thanksgiving all! I have made a real bonehead mistake this time. Hope someone can help.  I am trying to determi...georgetownjohn — 12:51 PM
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM

[-]
Who's Online
There are currently no members online.

>