1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
finally beginning 118
Glenn Roberts
Senior Member
****
Posts: 292
Threads: 17
Joined: Aug 2010
City: Yorkville IL
#46

06-23-2012, 08:43 PM
Well, I couldn't leave it alone..Icon_eh. After talking to Ron today, I put it back on the bench today. Ron suggested recleaning the tube sockets and checking the tubes. I checked the tubes, all good. I cleaned the sockets...well in the process of cleaning them I noticed a little bar attached to one of the tuning condenser mounting screws this was up against the band switch, but wasn't noticeable because of the conglomeration of wiring in this location. I moved it, secured and was able to align it and play it for over 2 hours today Finally. It's all together and playing...WooHoo.
A big thanks to all who provided suggestions and special shout out to Ron for his guidance and the piece of cloth to make it all look authentic. I'll post some pic's tomorrow, because it's time for dinner...
Glenn
Happily back in Illinois..not.
(This post was last modified: 06-23-2012, 08:43 PM by Glenn Roberts.)
Find
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#47

06-24-2012, 07:29 AM
All right! High five! Icon_thumbup Icon_clap
--
Ron Ramirez
Ferdinand IN
Find
TA Forbes
Deviate Emeritus
*****
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
#48

06-24-2012, 12:29 PM
GREAT news, Glenn! The 118 is a great performing set. I still maintain that Philco made some of the best eight-tube sets out there!!
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration