16B update

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode

16B update

BrendaAnnD
Phorum Expert

Posts: 1,107
Threads: 88
Joined: Jun 2011
City: Tacoma State, Province, Country: Washington

03-06-2013, 08:15 AM

I got my parts chassis for my 16B today. Tonight, I swapped out the LO coil for the high bands, and replaced the 700pf cap from the LO plate to the coil. This makes the last cap in the LO circuit. I also got in my 10K WW pot to replace the interstation noise pot.

Good news: all but the highest band are working extremely well. It will need a tiny bit of retweaking to bring the dial back into alignment. No biggie there.

Bad news: Band 5 is still not working properly. In fact, it now dies out at everything below 14 MHz. No matter what I do, I just can't get that bottom of band 5. Icon_sad

I've tried grounding the tuner rotor at various points, to no avail.

Anyone got any more suggestions what to try?

TIA

Find

« Next Oldest | Next Newest »

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

Who's Online

There are currently 3994 online users. [Complete List]
» 2 Member(s) | 3992 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me