Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 201X - Name plate in radio???
#1

I just finished stripping down a Philco 201X. It had lacquer on the inside as well as the outside. One thing I found when I cleaned the chassis board is an oval brass plate with the name of Powers on it. It is nailed in.
Did these radios get the name of the person who assembled the radio, or could this have been added after?
This radio has not been touched. The electronics are all original, and there was enough dust on it to make me think the insides have never been moved.
Has anyone seen this before?
Let me know.
Thanks
Chris

   
#2

Maybe the brass tag was put in there by a dealer? I have an RCA console where the dealer added their decal to the dial bezel.
Regards
Arran
#3

Aaron, I hadn't thought about that. I'll be the dealer put it on. For $250, this was a very expensive radio!
Thanks
Chris




Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 4006 online users. [Complete List]
» 1 Member(s) | 4005 Guest(s)
Avatar

>