Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hello, and a question
#1

Hi everyuone. I aquired a large Philco console yesterday, but i cannot find a schematic, Its a 41-269. I've asked at other place, and looked over many pictures to find one close to it, but with no luck, the tube lineup is odd, i think someone just plugged tubes in it, no rectifier, 2 differnt kinds of out puts. does have 2-#41's which i'm geussing is what is supposed to be the output tubes. Don't have much more information than that. I'm hoping some one here might reconize it, and would be able to give me a tube lineup thats correct.

Thanks
Jeremy
#2

Hi Jeremy

Sorry, Philco did not produce a 41-269. Maybe it is a 41-296? Can you provide photos to help identify it?

--
Ron Ramirez
Ferdinand IN
#3

Well it could be a 41-296, I might have misread the tag?..... Its a very large console radio, no phonoo player, Eight tubes, 41 P-P output. the other tubes seem to be whatever some one plugged in to take up space.its a 9 tube set. Has a very large speaker, over a foot in diameter. has a large rounded grill like and old car. Unfortunatley i put it in storge, as i have too much at home right now, and i didn't take a picture. THanks for the help
Jeremy
#4

Hi Jeremy

Well, I looked...Model 41-296 uses the same chassis as Model 41-285 (nine tubes). It is pictured and described here:

http://www.philcoradio.com/gallery/1941b.htm#j

The tube lineup is: (2) XXL, (2) 7B7, (1) 7A6, (1) 7C6, (2) 41, (1) 84.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>