Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46LW
#1

i would like to know if anybody knows the value or where can I find more information about this old radio from Canada, is a Philco 46LW code 121 in working conditions thanks.
#2

Hi and Welcome to the Phourm
Most of the folks deal with the US sets. There are a few CA members that may be able to give you some ideas. Would say just in general condition will weigh alot in terms of value. Some pics would be good just to see it's condition
Terry
#3

is in working conditions, I will upload pictures later but I was looking at the pictures that philco page has and I couldn´t find the exact one. thanks
#4

Did you look at the page on Canadian Philco radios on this site?

http://www.philcoradio.com/world/canada.htm

There were four different model 46 sets made in Canada in the 1941 season. One looks like a PT-2, another looks like a PT-4. Two others (46TL and 46TLI) are sets which I have not seen and do not have a visual reference to.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 4107 online users. [Complete List]
» 2 Member(s) | 4105 Guest(s)
AvatarAvatar

>