Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1938 Philco on "Lassie" TV show
#16

That may explain why I am wincing about this show being discussed right now, the episodes I saw all had John Provost in them, as "Timmy". Timmy is a name used for characters that are the butt of jokes now, probably because of Lassie or the Telethons. MeTV had some sort of showcase with Lassie and I was shocked to see that the episodes were all in colour without Timmy, those were from between 1966 and 69 I think. Lassie, who was a male collie during the whole run of the show and in every movie, seemed to be more independent in those colour episodes, more like the "Littlest Hobo".
Regards
Arran
#17

Not Lassie related but virtually any old Gene Autry movie is good for a cathedral or tombstone! The Western channel has been playing fully restored movies of his early in the mornings.




Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6111 online users. [Complete List]
» 4 Member(s) | 6107 Guest(s)
AvatarAvatarAvatarAvatar

>