Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 84 Ecap lead placement
#1

I am re-stuffing the can in my 84 and I am lost on where to put the leads. I replace an 8uf and a 4uf but I dont know what wires connect to them.

Do the 2 positives get twisted together and go to the rectifier?

Or do the 2 grounds get twisted?

Not sure of the schematic since I cant read them well.
Schematics here:
http://www.nostalgiaair.org/PagesByModel...013875.pdf

Any help on this is appreciated
Kirk

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#2

Kirk,

The top-side leads definitely do NOT get tied together. The 8 uF goes to the rectifier. The 4 uf goes to the top side side of cap 32.

The negative leads are electrically connected. Don't know if they need to be twisted together or not, whichever is easier. These leads go to the center tap of the power transformer and to Cap 28 and resistor 30.

Good luck.
Jon
#3

The pos go to your speaker (thats where all leads tie together on my 84)look at the sch at the x connections at white and green/white. When there is a dot on the sch that means that the wires are connected.
#4

DONE!
I have a working radio with complete recapping and no off value resistors!


THanks guys Icon_mrgreenIcon_mrgreen

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Restore Code ??
Can someone tell me if my 42 tubes are connected triode or pentode in fixed or cathode bias? How could I tell by looking...dconant — 10:47 AM
Philco 40-120C Restoration
Hello David, that is great news about the tubes source being local ! Sounds like you got good start on the radio . ...radiorich — 09:41 AM
An attempt to remove the Field Coil from a G speaker
Mike; I've only run into a speaker with an open filed coil twice, and they were on newer speakers from the 1940s. One ...Arran — 12:48 AM
An attempt to remove the Field Coil from a G speaker
Arran Yes, this is my plan for now and what do I got to lose, this is not even the speaker from this radio, but one o...morzh — 10:44 PM
An attempt to remove the Field Coil from a G speaker
Mike;  I would unwrap the field coil, and see if maybe there a break near one of the ends, like where the coil wire att...Arran — 10:23 PM
An attempt to remove the Field Coil from a G speaker
...and this is what I did. I fed a little LT into the screwholes with a small brush, and a little on the rim next to the...morzh — 09:52 PM
Philco 40-120C Restoration
I combined the two 40-120C threads together as we like to keep the discussion of the same radio together. It helps with...klondike98 — 09:36 PM
Philco 40-120C Weak, Distorted Ouput
Just checked were I buy tubes price is four dollars. So living in Florid we have a local source for tubes. David    David — 09:14 PM
Philco 40-120C Weak, Distorted Ouput
The higher voltage may be due to higher mains voltage. My mains run 120-125AC when the set was new mains would be 110-11...David — 09:09 PM
Philco 40-120C Weak, Distorted Ouput
Thank you for your reply. I pulled a speaker from a Philco 41-221 and received the same result. I used a signal tracer t...bluecap — 08:45 PM

[-]
Who's Online
There are currently 3796 online users. [Complete List]
» 2 Member(s) | 3794 Guest(s)
AvatarAvatar

>