Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

20B escutcheon
#1

I recently bought a model 20 deluxe and noticed that the escutcheon is similar but different than my model 20 plain. Has anyone actually seen a model 20 with the escutcheon used in the promotional sales pictures that looks more like a smaller 96H escutcheon?
#2

I never have.

Philco 21 sets use the same escutcheon as the 20, only the "PHILCO" is smaller. Perhaps this is what you have? Philco may have made the change during production of the 20 Deluxe.

--
Ron Ramirez
Ferdinand IN
#3

Yes, the "philco" is smaller and the horse shoe design at bottom center is larger and more open. I wonder if the bezel in the original picture was a concept design.
#4

Yup, it was a concept design. Early photos of the 70 and 90 show model 21 escutcheons and knobs, but I'm almost positive that Philco never used the 21 escutcheon on production 70 and 90 sets.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 2738 online users. [Complete List]
» 4 Member(s) | 2734 Guest(s)
AvatarAvatarAvatarAvatar

>