Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-116
#1

This is the first one of these I've worked on. Everything now works fine. Minor question is how many flood lights are there supposed to be? This set has three, two across the lower section of the dial and one above it, off to one side. Schematic seems to show only two. Since the set had previously been badly hashed, I'm suspicious. Thanks for looking.
#2

If this set is anything like 37-116 (I think it is) the latter has 4 flood lights. I am not counting the band lighting lense light.
Two on the top, right-left and two of the same on the bottom.
#3

Thanks Morzh. I looked at the 37-116 schematic and can see the four floods plus the pilot and the shadow meter lamp. Several small differences between the 37-116 and the 38 (of either code).
There are two places to mount floods above the dial center area. Guess I'll just go with the three.
#4

Those mounts are flat wide protrusions going left and right, correct? If there are only two, then yes - two floods.

As for shadow, I have Delux which does not have the shadowgraph.
#5

The two lower protrude left and right. The two upper point fwd.(away from the set) .
#6

Also the harness itself should be a tell-tell sign, it has a plug and then it is wired to all the sockets. In my case it is 4 sockets in one harness with a plug. If you have your harness the answer is right there.
#7

No plugs, the three leads are connected directly to the mag tuning switch/flood light switch. the switch had been broken and wired so the lights were always on, the AFC shorting section was distorted so it never made contact.
#8

Yeah...this one is the fun part.




Users browsing this thread:
[-]
Recent Posts
Replicating (dogbone) resistors what method have you used ?
John did you see the domino style capacitors that he made too. No, I did not see those Richard. I'll have to try and...Eliot Ness — 02:19 PM
Philco 89B code 123 newbie
Back to working on this, pretty much everything is done minus the RF coil, which I'm putting off until last.  Thanks for...Kurt P — 02:07 PM
Does the 20 Deluxe use photofinish?
I recently bought a can of oms and it now says Lo-odor mineral spirits. When I use citrus stripper I leave it on for...RodB — 11:09 AM
Does the 20 Deluxe use photofinish?
It's on a scale of how bad is it compared to... Naphtha, chlorine bleach, mek, and lacquer thinner it's odorless.Radioroslyn — 10:26 AM
Does the 20 Deluxe use photofinish?
Yeah, always wondered why they call them spirits "odorless". It sure enough smell like a gas station.morzh — 10:10 AM
Does the 20 Deluxe use photofinish?
I usually don't do any sanding till all the stripping is done. The veneer on the cabinet is thin and it is easy to sand ...Radioroslyn — 09:49 AM
HiFi (Chifi) tube amp build - but my own design.
As I remember it, the shock from that B+, about 250VDC, felt worse than the shocks I experienced from 220VAC.morzh — 09:14 AM
Hickok 288x
They worked for 85 years as .05's and my other machine which operated perfectly has them. Doubt thats the issue. What ty...daveone23 — 09:01 AM
462ron
LOL@ MrFixr. I remember an encounter with my first tube radio.. I think I have posted this before. Back when I knew just...462ron — 08:07 AM
HiFi (Chifi) tube amp build - but my own design.
I absolutely attribute my reaching 63 to God's benevolence, but this apart, it has never occurred to me to tap anything ...morzh — 07:55 AM

[-]
Who's Online
There are currently 2927 online users. [Complete List]
» 2 Member(s) | 2925 Guest(s)
AvatarAvatar

>