Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Phinds
#1

Phinally phound a 90 Cathedral at auction on Saturday.

Also phound a tabletop at antique shopIcon_biggrin
#2

Phantastique!
#3

Nice, your 90 still has the copper Mershon capacitors that look beautiful when polished up a bit.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#4

...and you can try to reform the Mershons.
Icon_lol just kidding.
#5

Both those radios look great, especially that Philco table model. Usually those are well beaten on when I find them around here.

No matter where you go, there you are.
#6

Great Phinds! ... Lucky!

The artist formerly known as Puhpow! 8)
#7

Thanks guys. I had a flipper bidding against me for the 90 but I wasn't backing-down!
#8

very nice......Good luck with them. You found a good bunch!
#9

Way to go, Tim!! Icon_thumbup
#10

Those Philco phinds look phantically phine! Icon_smile
#11

The contrast between the wood finish, the cream paint, and the grille cloth on the table model is sharp.

Paul

Tubetalk1




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4302 online users. [Complete List]
» 5 Member(s) | 4297 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>