Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco model 208 (code 122)
#1

Hi folks,

My 1st post here... I have been working on a very nice Philco 5-tube table top radio model 208, code 122. It's a Canadian model dating from the mid-to late 50s.

Reference: http://www.radiomuseum.org/r/philco_cdn_...e_122.html

It's that exact same radio except the case is dark burgundy and the speaker transformer is much smaller. It is in very good condition, all original parts and the case is nearly flawless.

I have been looking for a schematic for that model. I could manage without it, but i'd feel more comfortable having the schematic to navigate through the renovation process. I am going to restuff all the paper caps and can electrolytics and I could also compare part values with what's on the board.

Thanks for any and all help! Icon_biggrin

Robert, in Montreal
#2

Hi and welcome!!!
The large transformer in the back of the set isn't the output trans but an isolation transformer. Note the line cord connects to it. Don't know of a good source for Philco CA diagrams. The circuit is a very common one made by the millions or variations of it.
Terry
#3

Best of luck, Just Radios in Canada may help you locate schematic, but you may not need one. If you recap set and fix any other obvious problems, you may be OK.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>