Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco model #?
#1

Local radio but cant find model #

http://longisland.craigslist.org/atq/4415689836.html

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#2

42-390x perhaps?

http://www.philcoradio.com/gallery/1942a.htm#v
#3

Thats her I think.
thanks eX

Does anyone know how good of a performer this radio is?

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#4

Nothing terribly special except that it has the old FM band.
#5

I'd think the 42-390 would be a decent performer. I have a 42-355 with the same chassis. I pick up all kinds of distant stations on AM and SW even in my basement with just the built-in loop. The chassis is a devil to restore, though, because it has lots of crumbling rubber-insulated wire. There is also an enormous assembly combining the band switch, push-buttons, and power switch that is hard to re-wire.

The old FM band is useless, of course, though I can often pick up a strong local country station, probably from a harmonic in the converter stage. I didn't bother to align the FM on mine.

Restoration isn't really worse than any of the similar Philcos of the era with rubber wires, but it takes patience. It was actually one of the first few radios I restored. It took me a long time, but it didn't require any special skill or experience. If the band switch assembly is damaged or worn out, I don't know what you'd do.

John Honeycutt




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3813 online users. [Complete List]
» 1 Member(s) | 3812 Guest(s)
Avatar

>