Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-116
#1

Well it has happened again, found another 38-116! That's two this summer! It is 100% complete and the cabinet is in good condition but has been stripped and some what refinished. The chassis is nice and complete with a full set of engraved base Philco tubes. The owner says he was not able to get any reception and I have not tried. The power cord is in BAD condition. Grand total for this one $100. Not to sure what to do with this one, didn't really need another one but could not pass it by.

Gregb
#2

Gregb, at that price you have a lot of options. They are great radios and I'm certain someone within a local pickup area would return you a tidy profit. Super find and price. Post some pictures and you might excite some locals.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#3

Hi Jerry:
I will post a picture tonight but sad to say there are no locals near me, everyone goes to your part of the world. Its to cold here.

Gregb
#4

Greg: Many fond memories of in my early years traveling through your area. I like the city, of course it was summer. Our house had a wood burning heater in the living room! Nice to make it toasty in the winter of which we don't have much. We replaced it with a pellet stove, easier to control and a lot less smoke coming out. I never mastered the stacking of the wood and the old one required a lot of attention, not to mention removing ash. I prefer the cold to the hot, which we are now in.
Good luck on finding a home for that nice radio.
Best, Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#5

Being the hoarder that I am, I will most likely keep it.

Gregb




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>