Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

FM Reception 46-480
#1

Hope all had a nice holiday weekend. I get lousy FM reception in my area. Just a couple of stations and they are somewhat fuzzy. My 46-480 picks up several stations with the antenna I made but I have to turn the volume all the way up to barely hear anything. AM stations are just fine. Can anyone shed some light on the FM? I have a modern radio that picks up the same stations but I get plenty of volume from that radio. Thanks!
#2

Hi

Have all paper and electrolytic capacitors been replaced? Tubes checked? Set aligned? And...is the set's FM antenna connected properly?

--
Ron Ramirez
Ferdinand IN
#3

Thanks! Yes to all of the above. Everything went smoothly. I did have a problem with the Loctal sockets after I pop-riveted them back into the chassis. The heads of the rivets wouldn't allow the tubes to seat properly. I filed the heads and cleaned all the sockets per instructions found in another post and the tubes seat well now.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5146 online users. [Complete List]
» 1 Member(s) | 5145 Guest(s)
Avatar

>