Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-665 vs 37-660 Why ?
#1

I recently saw an ad for a 37-665, and began to research the radio. In looking through the wonderful resources on this site I found it is an amazingly nice design. I also am left a bit puzzled. The 37-660 seems to have a better band coverage for general shortwave listening, being continuous coverage from 2.3 MC to 18.2 MC, while the 37-665 goes much higher, up to 42 MC, but leaves a gap from 22 to 25 MC. What was the purpose of the gap from 22 to to 25 MC ? Were both this and the one from 1720 KC to 2.3 MC removed because they were "police bands" ? Also, and perhaps more important, what was the purpose of going so high in frequency with a home receiver? If any of our Philco gurus know, please let me know. I find it interesting. I would like to know the market they were trying to cater to.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6752 online users. [Complete List]
» 2 Member(s) | 6750 Guest(s)
AvatarAvatar

>