Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

zenith table sets, refresh
#1

 Here are two  zenith radios that needed some attention and so I gave them the (deluxe treatment) . Nothing fancy just a simple make over . One of them plays very nice and the other still needs some work to get it up and running but over all they are some good looking radios. I did not try to duplicate the photo finish the one radio although I could have done something with it Icon_eek


Attached Files Image(s)
                   
#2

Fred
They look great now. 
                Henry
#3

Fred I am green with envy  Icon_sick  Icon_sick. Wish I could do that.  Icon_thumbup Icon_thumbup Icon_clap Icon_clap
Joe

Joe Bratcher near Louisville, KY
#4

Very nice Fred. Nice and simple for sure.

Crist
#5

(11-01-2015, 12:56 PM)w4rtc Wrote:  Fred I am green with envy  Icon_sick  Icon_sick. Wish I could do that.  Icon_thumbup Icon_thumbup Icon_clap Icon_clap
Joe

You can with some practice




Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>