Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 610 Cabinet Color
#1

I picked up a Model 610 at the NJARC flea market this weekend and the case is in very good shape. Looking at pictures on the web I can not tell if the case is a single color, a medium brown on the one I have, or are the sides a darker color than the front panel. The lighting on web pictures can sometimes be decieving. Thanks.

Harv

Harv
#2

Hi

The center part of the 610B front panel is Medium Walnut. The rest of the front panel, as well as the remainder of the cabinet, should be a slightly darker shade; such as Perfect Brown or Medium Dark Walnut.

Most people (incorrectly) refinish these cabinets in a single color...yes, including the one on my site's Gallery.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron. I like the two tone look better, as shown in the Model 60 I restored, but wanted to make the 610 case as accurate as possible to its original state.

Harv




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>