Thread Rating:
  • 2 Vote(s) - 3.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Ron's 2016 Cabinet Work Part I: Bozak E-300

 Thanks Ron.
 Being my first attempt at a large transistorized stereo I lean toward it being my error somewhere that caused the condition. The one thing I hope points to something simple is after the pop when first turned on it plays just fine with no noise and good selectivity and sensitivity.

(09-05-2016, 01:45 PM)KCMike Wrote:  ...I hooked a Lafayette mpx to it and the sound was , well weird. You could hear the music but it sounded like two different stations playing at once and the words to the songs sounded like they were in a echo chamber.

It could be that your left and right channels were out of phase with one another...or else there is a problem with the Lafayette MPX decoder. Most likely the former.

Quote:Been looking for a fisher tube amp and MPX. Wow, they are sure proud of them on ebay.

You can say that again! I bought my Fisher 400 at Kutztown back in May for $275. On the auction site they usually ask double or more. And you can't find a 500 or 800 there for less than $1000. Icon_eek

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 11 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently 1784 online users. [Complete List]
» 1 Member(s) | 1783 Guest(s)
Avatar

>