Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Rca 151 oscillograph
#1

I opened up the oscillograph and noticed two capacitors in the same spot. When I looked at the schematic it said for 25-60 cycles add 8 Mfd. Didn't look at numbers on power transformer, doh! But I see T1 rated at 50-60 cycles and T2 rated at 25-60 cycles. Got this scope off e-bay. Question, can I plug into US household power and still live or did I just get burnt by European ratings. I'm at the office so I only have the schematic in front of me. Thanks.
#2

(12-02-2016, 11:54 AM)Paperboy Wrote:  I opened up the oscillograph and noticed two capacitors in the same spot. When I looked at the schematic it said for 25-60 cycles add 8 Mfd. Didn't look at numbers on power transformer, doh! But I see T1 rated at 50-60 cycles and T2 rated at 25-60 cycles. Got this scope off e-bay. Question, can I plug into US household power and still live or did I just get burnt by European ratings. I'm at the office so I only have the schematic in front of me. Thanks.

Your good. If it was designed for 60cy and you where powering it w/25cy that would be a problem.

Admin pls move to test equipment section.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Done. Icon_smile

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently no members online.

>