Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Back on the Farm - - Radio
#1

Restoration of an AK 768Q "farm radio".

http://www.russoldradios.com/blog/back-o...et-ak-768q

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#2

Another great job Russ!  I've always liked that style cabinet and bought one from a friend in the 80's with a 328 chassis in it.  This was before the Internet and everyone thought it was an original chassis...... I finally found a 447 chassis a few years ago, but it was tough to find.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#3

A++ Icon_thumbup Icon_thumbup Icon_thumbup
#4

One little note regarding the 447 - never try to pick up the radio by grabbing the top of the cabinet - as is too often done. The 447 chassis is so heavy that you will probably end up with a 2-part cabinet - the top separated from the bottom.

When I acquired my 447 this had been done by the auction company - THANKS!

The 768Q is light enough (no transformer) to not apply to this warning. Still maybe the glue has failed? Best to pick it up by the bottom.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#5

AK made some superbly looking radios.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#6

They tried to make their radios good quality too. Some of their choices like rubber insulated wire and the resistor design just didn't hold up as well as some of the options that they could have taken. No fault of theirs - as they say, only time will tell.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#7

What a Beautiful radio . I bet she plays as good as she looks. Nice job!  Icon_clap Icon_clap Icon_clap
#8

(06-09-2017, 07:50 PM)PhilcoJohn Wrote:  What a Beautiful radio . I bet she plays as good as she looks. Nice job!  Icon_clap Icon_clap Icon_clap

There are 2 videos of the radio in operation, in the post.

Yes it works very well except for it's limited audio  output frequency range.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/




Users browsing this thread:
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Mike; I've only run into a speaker with an open filed coil twice, and they were on newer speakers from the 1940s. One ...Arran — 12:48 AM
An attempt to remove the Field Coil from a G speaker
Arran Yes, this is my plan for now and what do I got to lose, this is not even the speaker from this radio, but one o...morzh — 10:44 PM
An attempt to remove the Field Coil from a G speaker
Mike;  I would unwrap the field coil, and see if maybe there a break near one of the ends, like where the coil wire att...Arran — 10:23 PM
An attempt to remove the Field Coil from a G speaker
...and this is what I did. I fed a little LT into the screwholes with a small brush, and a little on the rim next to the...morzh — 09:52 PM
Philco 40-120C Restoration
I combined the two 40-120C threads together as we like to keep the discussion of the same radio together. It helps with...klondike98 — 09:36 PM
Philco 40-120C Weak, Distorted Ouput
Just checked were I buy tubes price is four dollars. So living in Florid we have a local source for tubes. David    David — 09:14 PM
Philco 40-120C Weak, Distorted Ouput
The higher voltage may be due to higher mains voltage. My mains run 120-125AC when the set was new mains would be 110-11...David — 09:09 PM
Philco 40-120C Weak, Distorted Ouput
Thank you for your reply. I pulled a speaker from a Philco 41-221 and received the same result. I used a signal tracer t...bluecap — 08:45 PM
Philco 40-120C Weak, Distorted Ouput
Have you tried a different speaker? How did you trace the distortion? How do you know it is weak? What is the reference?...morzh — 08:33 PM
Philco 46-480 Electronic Restoration
Amen to that! Every time I think I’ve captured them all, I realize that there’s another error. My goal is to finish with...jrblasde — 07:00 PM

[-]
Who's Online
There are currently no members online.

>